To Previous Page

Property of Monitronics Inc

Monitronics Monitoring and Service: 1-800-447-9239

DSC PC1575 Quick Reference Guide

Arm Away

Hold AWAY key for 2 seconds (if available)

or enter User Code

Arm Stay

Hold STAY key for 2 seconds (if available)

or enter User Code and do not leave

Instant Doors Press ¬ 9 then enter User Code

Disarming /

Silencing Alarm

Enter 4 digit code

Press # key if a mistake is made entering User Code or to eliminate flashing keypad if an alarm has occurred

Zone Bypassing

Press ¬ 1 then enter Zone to bypass (1 to 6) (Zone bypassed will light on keypad)

When finished press #

Note:

Some systems may require pressing ¬ 1 + Master Code then the zone to bypass (1 to 6)

User Codes

Press ¬ 5 then enter Master Code

Enter User (1 to 6)

Enter new 4-digit User Code then # to exit

To erase a code repeat steps above except enter¬ instead of a new User Code

The 1

code is the system Master, the 6

code is a Hostage (if programmed)

Door Chimes

Hold CHIME button for 2 seconds (if available)

or press ¬ 4

Reset Smoke Detector Press ¬ then 72

Trouble Light

If SYSTEM or TROUBLE Light turns ON press ¬ then 3

Light 1: Battery trouble Light 2: AC loss Light 3: Communications Trouble

Light 4: Zone fault Light 5: Zone Tamper Light 6: Loss of Time

Alarm Memory Press ¬ then 3, the zone or zones that caused last alarm will flash.

Created by Mark Leuck 02/02/2002 Monitronics International, Inc.

DSC PC1575 Programming Guide

Other manuals for DSC PC1575