DSC PC560 - Zone Alarm and Restoral Reporting Codes Worksheet; Opening and Closing Reporting Codes Worksheet

21
[11] Zone Alarm and Restoral Reporting Codes Page 16
For single digit reporting codes, enter [0] as the second digit.
Zone 1 Alarm Enter [
∗
1
∗
] (HEX A) to transmit a “0” (zero = 10 pulses)
Zone 2 Alarm
Zone 3 Alarm
Zone 4 Alarm
Tamper Alarm
Zone 1 Restoral
Zone 2 Restoral
Zone 3 Restoral
Zone 4 Restoral
Tamper Restore
NOTE: 24-Hour and Tamper Zone restorals are transmitted when the zone is restored. All other
restorals are transmitted on Bell Time-out or on disarming, depending upon the option
selected in Section [07].
[12] Opening and Closing Reporting Codes Page 16
For single digit reporting codes, enter [0] as the second digit.
Closing, Access Code 1 Enter [
∗
1
∗
] (HEX A) to transmit a “0” (zero = 10 pulses)
Closing, Access Code 2
Closing, Access Code 3
Closing, Access Code 4
Opening, Access Code 1
Opening, Access Code 2
Opening, Access Code 3
Opening, Access Code 4
Opening After Alarm Code