DSC Power 864 - Section 8: System Information; For Service Information; Access Codes and System Setup

Setting the You should make sure that your system has the correct time and date. This is important for
Time and Date the auto-arm feature to function correctly, and for accurate reporting of events.
1. Press ® ® [Master Code] ®.
2. The keypad will now accept 10 consecutive digits:
• Enter the time in hours and minutes using the 24-hour format (00:00 to 23:59).
• Enter the date in months, days and years (MM DD YY).
4. To exit programming, press ®.
NOTE: If you have an LCD keypad, your installer may have programmed your sys¬
tem to display the time and date while the keypad is idle. If this is the case, you can
press the Q key to clear the date and time display.
Changing the You can change the language displayed on the LCD5500Z keypad.
1. Press and hold both of the C<][>) keys together.
2. The keypad will enter Language Selection mode. Scroll to the language you want the
keypad to display.
3. To select a language and restart the keypad, press ®.
You can change the brightness and contrast of the LCD display on LCD5500Z keypads.
1. Press ® ® [Master code],
2. Use the (2[B5 keys to scroll to either Brightness Control or Contrast Control.
3. Press ® to select the setting you want to adjust.
4. A) 'Brightness Control': There arel 0 different backlighting levels. Use the keys
to scroll to the desired level.
B) 'Contrast Control': There are 10 different display contrast levels. Use the C<][>)
keys to scroll to the desired contrast level.
5. To exit, press ®.
LCD5500Z
Display
Language
Changing
LCD5500Z
Display
Brightness/
Contrast
Changing
Keypad
Sounder
Loudness
You can select from 21 different keypad sounder tones for LCD and PC55XXZ keypads
From an LCD5500Z keypad:
1. Press ® ® [Master Code],
2. Use the C<]S^ keys to scroll to the message 'Select Option <> Buzzer Control'.
3. Press ® to select.
4. Use the C<][E^ keys to scroll to the desired keypad sound level.
5. To exit, press ®.
From a PC55XXZ or LCD5501Z keypad:
Press and hold the ® key until the desired keypad sounder level is reached.