DT311C/ DT311H
Buon Funcons
BUTTON ACTION
Programmable buon
Power buon
RF switch
Baery Latch
• Push the switch up to unlock the latch, then slide the latch le to remove the baery.
Input/ Output Ports
USB 3.0 Port
Headphone Jack
DC Power Input
Smart Card Reader
Back Camera (oponal)
The DT311C/ DT311H
1
2
3
4
A
B
C
Baery/Power LED
2
3
4
1
E
D
D
E
A
C
B
ENGLISH
2
3
ENGLISH
Power/Baery LED Status:
Blue indicates the baery is 25% to 100% charged•
Blinking blue indicates the baery is charging•
Orange indicates that the baery is between 11% to 25%•
Blinking Orange indicates that the baery is below 10%•
Precauons
Always exercise care when operang and handling the
• DT311C/ DT311H
.
Do NOT apply excessive pressure to the display screen.
•
We recommend using the Digit
al Pen (oponal) to keep the screen clean.
•
A
•
void prolonged exposure of the display panel to any strong heat source. Wherever
possible, the
DT311C/ DT311H
should face away from direct light to reduce glare.
If the AC-DC power adapter is used to recharge or power the tablet, do NOT use any
•
AC-DC adapter other than the one provided or acquired from the manufacturer or its
partners.
In the unlikely
event that smoke, abnormal noise, or strange odor is present,
•
immediately power off the
DT311C/ DT311H
and disconnect all power sources. Report
the problem to your device provider immediately.
Never aempt to disassemble the
• DT311C/ DT311H
, as this will void the warranty.
THE DT311C/ DT311H
Basic Features
The DT311C/ DT311H wireless tablet integrates a bright display, one USB port, and
embedded n
etworking elements such as wireless LAN and Bluetooth or oponal
3G/ 4G. The DT311C/ DT311H is complemented by a suite of accessories, including
baery expansion, charging cradles, and baery charger kit, for a comprehensive user
experience.
A DT311C/ DT311H typically integrates an 802.11ac wireless LAN (WLAN) adapter that
may connect to other wireless devices or access points. If your DT311C/ DT3
11H does not
come with such a network adapter, please consult your device provider to establish the
desired network connecvity.