DT Research DT391GS User Manual

DT391UF/ DT391GS
5
ENGLISH
Start Up
If the power up (from Standby or otherwise) is successful, the appropriate interface will
be displayed aer a launch sequence of several seconds. The wireless LAN connecon
may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT391UF/ DT391GS may be configured using the ulies and methods dictated
by the soware operang system. The DT391UF/ DT391GS should be configur
able for
various properes such as user profiles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT391UF/ DT391GS is oen delivered with an embedded (user-inaccessible)
802.11a/b/g/n WLAN adapter equipped with a hidden custom antenna.
T
• hrough the support of typical WLAN adapters, the DT391UF/ DT391GS should be
able to detect all 802.11 access points in the vici
nity for you to select the access
point of your choice for connecon.
T
• he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT391UF/ DT391GS
and the access points have to match. The SSID is case-sensive and it is recom-
mended that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for
secure access.
W
• hen WEP/WPA/WPA2 is enabled, you may need to consult your network admin-
istrator or
your networking equipment literature to properly configure associated
sengs such as Authencaon mode, etc.
R
• efer to the access point operang manuals for seng up the 802.11 access points.
ENGLISH
4
OPERATION
Powering ON and OFF
To acvate the Tablet basic, push and quickly release the Power Buon. The display
will come on in a few seconds. To put the DT391UF/ DT391GS in Standby mode, push
and quickly release the Power Buon. To turn the DT391UF/ DT391GS off for extended
storage, power off safely using any soware funcon that
“
shuts down computer
”
provided in the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power
—
please use the
AC-DC adapter with the DT391UF/ DT391GS when seng up for the first me to
fully charge the internal baery pack. You may charge the external baery pack
by aaching to the DT391UF/ DT391GS while it is plugged in, or with the oponal
external baery charger kit.
NOTE:
When the baery pack(s) is (are) charging, the blue-col
ored Baery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
acvity and the LED stays dark, the baery pack(s) may have been drained
substanally. Try unplugging/ replugging the AC-DC adapter to the DT391UF/
DT391GS a few mes to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in
“
Standby
”
mode while not in use. Pushing briefly on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (
“
hold 4+ seconds
”
feature) to turn off the
tablet
—
this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.

DT Research DT391GS Specifications

General

Brand	DT Research
Model	DT391GS
Category	Tablet
Language	English