DTF STATION Miro 13 - Safety Instructions; General Operation Safety; Equipment Integrity and Repair; User and Electrical Safety

1
Safety Instructions
When using your Smoke purier,
basic precautions should always be followed,
including the following:
1. Read all instructions.
2. Use smoke purier only for its intended use.
3. To reduce the risk of electric shock, do not immerse the smoke purier in
water or other liquids.
4. Never pull cord to disconnect from outlet, instead grasp plug and pull to
disconnect.
5. Do not operate smoke purier with a damaged cord or if the equipment
has been dropped or damaged.To reduce the risk of electric shock, do not
disassemble or attempt to repair the smoke purier. Take it to a qualied
service person for examination and repair. Incorrect assembly or repair
could increase the risk of re, electric shock, or injury to persons when the
equipment is used.
6. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
7. Close supervision is necessary for any smoke purier being used by or
near children. Do not leave equipment unattended while connected.
8. To reduce the likelihood of circuit overload, do not operate other high
voltage equipment on the same circuit.
9. If an extension cord is necessary, then a 20 amperage rated cord should
be used. Cords rated for less amperage may overheat. Care should be
taken to arrange the cord so that it cannot be pulled or tripped.