DTF STATION Miro 13 - Operation Instructions; Main Heating Temperature Setting; Pre-heating Temperature Setting

5
Operation Instructions
Please scan the QR code here to see the playlist of all installation/maintenance videos:
1. Install the lter
2. Install the lm collector
3. Loading media lm
4. Adding powder
5. Changing lter board
6. Daily maintenance
7. How to set main heating temperature and pre-heating temperature
(1)Main heating temperature setting
Short press SET until screen shows as below, to set the main temperature
at 120 °C, then press SET two times to conrm the setting and exit setting
interface.
(2)Pre-heating temperature setting
Short press SET until screen shows as below to set the pre-heating
temperature at 50°C, then press SET two times to conrm the setting and exit
setting interface.
The default setting parameter Preheating (SP02): 50 °C main heating (SP01): 120 °C was
based on 25 °C room temperature; the parameter setting might need to adjust according to
the actual environment temperature.