DTS NETIMPRESS avant - 3 Name and Function of the Components; Name of Components

13
3. Name and Function of the Components
3.1. Name of Components
Target Connector 1/2
This is the connector to
connect the probe that
connects with a target.
system.
BCR Connector
This is the connector to
connect the probe that
connects with a bar-code
reader.
DIO Connector
This is the connector
to control by Digital
I/O.
SD CARD Slot
Slot for inserting the
SD card.
POWER SW
Power switch for turning on-off.
the power source
AC Inlet
Connector for AC cable dedicated
to NETIMPRESS avant.
LAN Connector
Connector for Ethernet.
LCD
Displays various information,
such as model name of definition
program and address etc.
KEY
This is used when operating
NETIMPRESS avant as a
stand-alone.