DTS NETIMPRESS avant - Function of Components

14
3.2. Function of Components
 Function of each key when operating NETIMPRESS avant as a stand-alone
8 keys are used when operating NETIMPRESS avant as a stand-alone.
Following table describes function of each key and the behavior.
QUIT
 QUIT button is used when you want to stop the operation.

When you are operating MENU, it backs to the previous item by
pressing the button.
SET  SET button is used when you want to set and execute the settings.
MENU  MENU button is used when you want to display the menu window.
EXT1/EXT2
 EXT1/EXT2
buttons are used to read corresponding execution file
and sequence it.
▲
(Up)
 Arrow key is used when you want to scroll the mode setting menu or
the command setting menu.
 This is also used when selecting MENU.
▼
(Down)
 Arrow key is used when you want to scroll the mode setting menu or
the command setting menu.
 This is also used when selecting MENU.
◀
(Left)
 This is also used when selecting MENU.
▶
(Right)
 This is also used when selecting MENU.