7.1-DMX Addresses
XR9 can be used in two different modes: 18 or 26 DMX (default) channels.
If you want to use the XR9 in 18 channels mode, select the 18 CH mode from the MODE menu and set
the following addresses on the mixer:
Projector 1 A001
Projector 2 A019 If you want to select the next projector, just add “18”
Projector 3 A037
….. A….
projector 6 A091
If you want to use the XR9 in 26 channels mode, select the 26 CH mode from the MODE menu and set
the following addresses:
Projector 1 A001
Projector 2 A027 If you want to select the next projector, just add “26”
Projector 3 A053
….. A….
Projector 6 A131
7.2-Selecting the DMX address
1) Press the UP-DOWN key until you reach the required DMX channel. The numbers on the display will
start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop flashing and the
projector is now setted to the new DMX address.
TRICKS:
if you keep pushed the UP or DOWN keys, the channels are calculated more quickly and you get a
faster selection.
10
XR 9 SPOT
To Next Page
Loading...
Need help?
General
