Dual 1219 - Operating the Dual 1219; Single-Play Mode Operation; Multi-Play Mode Operation; Playback Control Functions

Operating instructions
Speed selector
Piten-control kn
‘Tonearm lit and tock
Rotating single-play spindle
ca
igo
holder
TTonearm
ledge
(motor
smains on)
Tonearm rest (motor ts shut off)
Tonearm tock
Tonearm eve-controt height
Stylus fore
justment
Tonearm counterbalance
Muitipte:play spindle for ar
‘Adaptor for large-hole records (alngle-play)
Mumpt
por
Record size
Tor
NY spindle
Cue-controt
Chassis
ao
ert)
ating force adjustment
Mode solector
8208S G98S98G88S8 900090900090
Operation in single-play mode
Mode
selector
@
in
position
“single”
Set the mode selector for single play.
Insert
the
short
single-play
(and,
for
45
rpm
records,
the
center-hole
adapter).
Set
the
motor
speed
and
record
size
selec:
tor
for
the
record
to
be
played.
Unlock
the
tonearm,
(Fig.
7)
and
the
1219
is
ready
for play.
Fig. 6
4. Automatic start
Push the operating switch to “start*. The
motor will start, the tonearm will rise,
move to the record, then descend smooth-
ly to the record. The slow descent rate
of the cue-control functions automatically.
Fig.7
2. Manual start
Place the tonearm on the record by hand.
(As
you
move
the
tonearm
from
the
rest
post
toward
the
record,
the
platter
will
begin to rotate.)
3. Manual start with cue-controt
'3) Move the cue-control lever to posi
tion ¥
b) Place the tonearm over the record
where you would like play to begin.
¢) Tap the lever back to position ¥
(The tonearm will descend.)
4. To repeat a record
Push the operating switch to “start*.
5. To interrupt play
Move the cue-control lever to ¥
6. To resume play where it was inter-
rupted
Move the cue-control lever to¥..
(A light tap will do.) The last few bars
will be repeated,
7.
To
stop
Move the operating switch to
tonearm will return to its rest and the
motor will shut off
Note: After a single record has played,
for after the last record in a stack has
been played, the tonearm will return au-
tomatically to its rest, and the motor will
shut off. It is advisable then to lock the
tonearm on its rest. (Fig. 7)
Operation in multi-play mode
Mode selector @ in position “multi
Set
the
mode
selector
for
multiple-play.
Insert
either
the
multiple-play
spindle
(Fig. 10) or the special spindle (Fig. 11)
for large-hole 45 rpm records: Place the
key at the base of the spindle into the
slot of the shaft, press the spindle down,
then turn it to the right until it stops.
Fig. 10
‘Stack up to six records of the same size
and speed on the multiple-play spindle
‘AW 3 or the special one for large-hole
45 rpm records.