Installation
Before You Start
* To test remote connection.
With the receiver turned off, plug the cable in to both the receiver and the
remote control. Turn on the receiver and test the functions of the remote control.
* Choose and prepare location.
MWR15 is designed to be mounted in a 2"(50mm) gauge cutout.
Mounting depth will vary, but at least 2.5" is needed to mount the remote control.
NOTE: Be sure to check behind the panel for wiring harnesses, steering cables,
hydraulic lines, fuel lines, gas tanks, etc. Also make sure you can get behind
the dash panel, bulkhead, etc. to to be able to attach the mounting bracket.
Do not mount the unit where it will be submerged.
4
To Next Page