Dualit Toaster - Resetting the Thermal Fuse; Cool and Unplug Toaster; Access Fuse Location; Reset the Fuse

Unplug the toaster
and allow to fully cool.
Remove the crumb tray and
toaster base plate to access
the fuse.
The fuse can be located
in the rear corner of the
toaster body.
The appliance must be PAT
tested before use.
PAT
TEST
The fuse is reset by
depressing the small white
button on its face.
1 2
5
3
6
4
VARIOGBADD-A
Dualit Limited County Oak Way Crawley West Sussex RH11 7ST
t: +44(0)1293 652 500 | e: info@dualit.com | www.dualit.com
If the toaster neon illuminates, but the elements fail to warm up or if there is an audible
‘click’ above the normal ticking of the timer from the toaster while it is still operating, you
may have activated the Thermal Protection Device.
Before resetting you must ensure that there is not a fault within the appliance. Do not reset
unless a qualied electrician has examined the toaster and veried that the Selector Switch,
Timer and all other Components are in good working order.
The Thermal Protection Device can be reset by allowing the toaster to fully cool,
unplugging the toaster from the wall socket and following instructions below.
Resetting the Thermal Protection Device should only be carried out by a qualied
electrician. The toaster must be Portable Appliance Tested following reset of the
Thermal Protection Device. Should you require any further assistance call Dualit’s
Service Department on 01293 652 500.
RESETTING THERMAL FUSE
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
Rex the base plate and
return the crumb tray.