Dualsky Summit ESC - Status and Tones Overview

3
* Arc protection * Power-on overvoltage and under voltage protection * Unsafe throttle signal
protection * Low voltage protection * Out of control protection * Stall protection * Out of step protection *
Over current protection * Over temperature protection * Short circuit protection
SUMMIT ESC status and tones
Subject
Tones
Built-in LED
ExternalLED
Operation
Red
Green
HV ONLY
No throttle
signal
1 short and long
tone repeat
(Summit HV
sleep)
Off
Off
On
Check the throttle/receiver and it will
return to normal when there is signal
Unsafe
throttle signal
1 short tone
repeat
Off
On
On
The throttle is too high, returning to
normal after the throttle is low
Throttle
signal loss
N/A
Off
Off
Off
In working state, throttle signal loses
more than 0.2S, motor stops, motor
resumes when throttle is normal; throttle
loses more than 3S, it enters to no throttle
signal processing mode.
Power-on
under
voltage
3 short tone
repeat
Off
On
On
Battery voltage is too low (less than
13.2V), check the input voltage and then
power on again
Power-on
overvoltage
4 short tone
repeat
Off
On
On
The battery voltage is too high (higher
than 4.2V/CELL), check the input voltage
and power on again.
Working low
voltage
protection
N/A
Off
Single
flash
Slow flash
Low battery voltage, motor power limit of
60% (multi-rotor version is not limited to
power)
Out of step
protection
N/A
On
Off
On
Try to recover after the throttle is lowered
Stall
protection
N/A
On
Off
On
Try to recover after the throttle is lowered
Short circuit
protection
N/A
Three
flash
Off
Slow flash
Internal operation
Over current
protection
N/A
Double
flash
Off
Slow flash
Internal operation
Over
temperature
protection
N/A
Single
flash
Off
Slow flash
Internal operation