2、 Change the engine oil (see page 25-26).
3、 Remove the spark plug, and pour about a tablespoon of clean engine oil into the cylinder. Crank the
engine several revolutions to distribute the oil, then reinstall the spark plug.
-
- 39 -
4、 Slowly pull the starter grip until resistance is felt.
At this point, the piston is coming up on its compression
stroke and both the intake and exhaust valves are
closed. Storing the engine in this position will help
to protect is from internal corrosion.
ASSEMBLY OF
PARTS
Battery
To install the battery, proceed
as follows:
1. Assemble the battery with
nuts, bolts and washers.
2. Connect the starting cable
to the starting motor terminal
alone the bottom of the fuel tank.
3. Connect the earth line with
To Next Page
Loading...
