Ducar DGPW3200 - Adding; Checking Engine Oil; Adding Fuel

To Next Page

To Previous Page

ASSEMBLY

• Place pressure washer on a level surface.

•

• Carefully add between 520 ml (17.6 oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches

• Be sure to replace both dipsticks before attempting to start the engine.

• To check oil, set pressure washer on a level surface, wipe dipstick clean, then reinsert dipstick without re-threading.

FIG 5

Adding / Checking Engine Oil (See fig 5)

• Set pressure washer on a clean and level surface in an area that is well ventilated.

• Remove fuel cap.

• Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1 1/2 inches below the

top of the neck.

CAUTION!

Adding Fuel (See fig 6)

FIG 6

To avoid spillage, fill below screen level. Do not overfill fuel tank as gasoline expands.