Ducar DUELT24-4 - Rules for Correct Operation

19
INSTRUCTION MANUAL
GB
%5HSODFH WKH VLOHQFHU LI LW
LV IDXOW\
RU GDPDged.
%%HIRUH XVH DOZD\V YLVXDOO\ FKHFN WKDW
WKH
blade, the blade fastening screws and the
cutters are not worn or damaged. Replace
DQ\GDPDJHGRUZRUQEODGHVDVZHOODVWKHLU
fastening screws in complete series to maintain
proper balancing. Repairs and maintenance of
PHFKDQLFDOSDUWVPXVWEHGRQHE\D
VSHFLDOLsed after-sales centre.
58/(6)25&255(&7
OPERATION
C 1 HAZARD! Do not operate the engine
in a secluded or restricted area where
WKHGDQJHURXVFDUERQPRQR[LGHFRQWDLQHGLQ
WKHH[KDXVWIXPHVPD\EXLOGXS
C 22QO\RSHUDWHRQJURXQGVWKDWDUHOLWE\GD\OLJKW
RUE\DGHTXDWHDUWL¿FLDOOLJKWLQJ
& Before starting the engine, disconnect the
blade, place the gearshift in “neutral” (N) and
engaged the parking brake.
& As far as possible, avoid using the lawn
tractor on wet grass.
C 5'RQRWRSHUDWHRQH[FHVVLYHO\VWHHSVORSHV
Check the limits indicated in the manual.
CAUTION - Risk of overturning on steep
gradients.
# Do not use the machine on lawns with
gradients of more than 25% (14°).
# Do not use the machine on lawns with side
gradients above 15% (8°).
C 6 Remember, there is no such thing as a “safe”
gradient. Moving on sloped lawns requires
VSHFLDOFDUHDQGH[SHULHQFH
To prevent overturning:
 QHYHUVWRSRUVWDUWVXGGHQO\RQVORSHV
 HQJDJHWKHGULYHJHQWO\DQGDOZD\VNHHSD
GULYHJHDUHQJDJHGHVSHFLDOO\RQGRZQZDUG
slopes;
- speed must be reduced on slopes and sharp
bends;
- never move down slopes with the gear shift
in neutral (N); engage a lower gear;
- be careful of mounds, bumps and hidden
hazards;
QHYHUPRZDFURVVVORSHVEXWDOZD\VHLWKHU
up or down.
&%H YHU\ FDUHIXO ZKHQ FKDQJLQJ GLUHFWLRQ RQ
slopes.
&6WRSWKHEODGHZKHQFURVVLQJWHUUDLQRWKHUWKDQ
lawns and when the lawn tractor is transported
to and from the work area.
C 9'RQRWXVHWKHODZQ tractorZLWKIDXOW\JXDUGV
RU ZLWKRXW VDIHW\ GHYLFHV ¿WWHG VXFK DV IRU
H[DPSOHWKHJUDVVEDJ
&'RQRWPRGLI\WKHHQJLQHDGMXVWPHQWVDQG
to not tamper to increase the engine speed. If
the speed of the engine is too high, this could
cause personal injuries.
C 11 Disengage the blade and drive control before
starting the engine.
C 12 +DQGV DQG IHHW PXVW EH NHSW DZD\ IURP
WKHEODGH$OZD\VNHHSDZD\IURPWKHJUDVV
unloading opening.
& Before leaving the driving seat:
- place the gearshift in neutral (N) and engage
WKHSDUNLQJEUDNH¿J
- disengage the blade and lower the blade
deck;
 VWRSWKHHQJLQHDQGUHPRYHWKHNH\
& +$=$5'   %HIRUH FDUU\LQJ RXW DQ\
inspection, cleaning and servicing
operations on the machine, before
unblocking the grass unloading pipe,
stop the engine, take out the ignition
NH\DQGIROORZWKHLQVWUXFWLRQVLQWKH
manual.
+$=$5'7KHEODGHVDUHVKDUS
ULVN RI VHULRXV LQMXU\ %HIRUH FDU-
U\LQJ RXW DQ\ LQVSHFWLRQ FOHDQLQJ
and repair operations on the cutting
parts, stop the engine and take out
WKH LJQLWLRQ NH\  1RZ GLVFRQQHFW
the spark plug wire, and keep the
FDSDZD\IURPWKHSOXJ¿JWR
prevent accidental starting.
+$=$5'7KHEODGHVDUHVKDUS
ULVNRIVHULRXVLQMXU\:DLWIRUWKHEOD-
de and all the moving parts to come
to a halt before touching them. The
blade will continue turning for some
time after switching off the engine or
disabling the blade control.
> 25%
> 25%
> 15%
STOP