84
DEFAULT function
(Resetting Ducati default parameters)
This function resets the parameters set by Ducati for
each riding mode.
To access the function it is necessary to view the
“setting” menu page 72; using button (1, fig. 23)
“▲” or (2, fig. 23) “▼” select the “RIDING MODE”
function and press the reset button (12, fig. 21) to go
to next page. Use button (1, fig. 23) “▲” or (2, fig. 23)
“▼” to select the riding mode to be reset to default
(initial) parameters and press the button (12, fig. 21)
to access the next page. Now, using button (1,
fig. 23) “▲” or (2, fig. 23) “▼” select “DEFAULT”
indication.
To restore original default parameters, press and hold
the reset button (12, fig. 21) for 3 seconds.
For the parameter reset, approx. 3 seconds are
needed during which “PLEASE WAIT…” will appear
on the display; at the end of the procedure,
”DEFAULT OK” will appear on the display to indicate
that the parameters were reset.
DTC DEFAULT
SPORT
ENGINE
EXIT
PLEASE WAIT...
DEFAULT OK
DTC DEFAULT
SPORT
ENGINE
EXIT
SPORT TOURING
RIDING MODE
URBAN
EXIT
fig. 55
Press RESET
Press RESET
Press RESET for 3 sec.
ProCarManuals.com
To Next Page