64
9.
10.
11.
1. Starting from one of the two ends
of the handlebar, wind the tape from
the inside to the outside, putting the
adhesive part of the tape on the end of
the handlebar.
2. Then wind the tape leaving about 1
cm of distance between one layer
and the other, in a slightly diagonal
direction to continue towards the high
part of the handlebar.
3. Once you reach the command
handlebar, rst go behind it, winding
the handlebar and command
together, then have the tape go
around toward the upper part.
4. From the upper part wind the
handlebar and command again going
downward.
5. Now wind the tape around the
section of the handlebar behind the
command lever.
Then the tape goes again around the
upper part.
6. From the upper part wind the tape
up until the beginning of the palm
area or to the selected spot, assessing
the length of the tape still available.
7. After winding the last part, cut the
tape diagonally, from the outside to
the inside.
8. Making sure that the cut section
of the tape remains under the visible
part of the handlebar, we can now
apply 2 layers of black tape for cables
8.
Below you will see all the steps
to follow, along with pictures, to
position the tape correctly.
To Next Page
Loading...
