Ducati FUTA - Page 65

65
EN
Use and maintenance manual
Warning!
When tightening the screws,
observe the torque indicated
on the screws or refer to the
“tightening torque” table in this
manual.
Warning!
We recomand not adding
accessories or equipment to the
bicycle yourself or attempting
modify it. For any accessiories
(mudguards, lights, etc.), always
choose quality components and
seek advice from a specialised
dealer.
into contact with lubricants of any
kind; this could contaminate the
braking system and seriously aect
the performance of the vehicle,
jeopardising driving safety. Should
this situation occur, have the
contaminated components checked
and replaced by an experienced
mechanic before using the bicycle
again.
(or the scotch tape provided together
with the handlebar tape).
9. Finally, close the extra tape, at the
ends of the handlebar, by pushing it
toward the inside of the tube section
of the handlebar.
10-11. Block the extra tape by
pushing into the hole of the handlebar
the dedicated cap provided in the
package of the handlebar tape.
Now repeat the same operation on
the opposite side of the handlebar,
trying to obtain as symmetrical
a positioning as possible with
respect to the previously wound
tape.
To hone your technique and
achieve optimal tape placement,
we recommend viewing the
many tutorials available for free
online dedicated to this particular
operation.
– Important notes for proper
functioning of the brake system:
We do not recommend changing
the pads of the brakes on your own
if you lack sucient experience;
in this case, nd a qualied bicycle
shop. The warranty on the goods
lapses if the replacement process is
not carried out correctly.
The braking surface of the brake
disc and pads must never come