Ducati FUTA - Page 73

73
EN
Use and maintenance manual
Warning!
• Do not deform, modify or
disassemble the battery or weld
directly on it.
• Do not leve the battery near
sources of heat. Do not heat the
battery.
•Do not expose the battery to
strong shocks.
•Do not immerse the battery in
water; prevent connectors from
getting wet.
•To charge the battery, only use the
specic FSA battery charger and
follow the indicated rules.
• If the liquid spills out of the
battery and comes into contact
with your eyes, rinse the aected
area immediately with water
without rubbing your eyes and
contact a physician. If these
instructions are not followed, this
can result in eye damage.
Not following these instructions
may result in leaks, overheating,
explosion of the battery or the
battery catching re.
• The Range Extender can be
disconnected only when the System
FSA is o.
– Recharging the Range Extender:
• Apply the charging adapter to the
connector of the Range Extender.
• Plug in the charger (LED on the
charger indicates green).
•Connect the charger to the Range
Extender through the charging
adapter positioned previously.
•Wait until the LED of the Range
Extender starts ashing and then
press the control button only once
for the charging process to begin.
•The charging begins when the LED
on the charger shows the colour red,
and the LEDs on the Range Extender
indicate the state of the charging
process.
• Once the charging process is
complete, the LED of the charger
will show the colour green.
– Reading the state of charge
when the Range Extender is not
connected to the System:
•The Range Extender features a
control button and two LEDs.
•By pressing the control button, also
when the Range Extender is o, you
can quickly read the state of charge.
• The state of charge indicated
by the LEDs can be read in the
following way:
-100-75% with both LEDs xed
with the colour green
-74-50% with one LED xed and
one ashing, both green
-49-25% only one LED xed with
thecolour green
-24-0% only one LED ashing
the colour green