Ducati Monster 696 2009 - Refitting the Oil Breather Valve; Removal of the Oil Breather Valve

A
B
C
D
E
F
G
H
L
M
N
P
section
L 7
33Monster 696/696+ - M.Y. 2009 - edition 00
Fuel/Exhaust System
Removal of the oil breather valve
Undo the screw (13) and remove the oil breather valve (14) from the crankcase half.
Check the condition of O-rings (15) and renew them if necessary.
Refitting the oil breather valve
Lubricate the two O-rings (15) with engine oil.
Insert the oil breather valve (14) in the hole in the clutch-side crankcase half, aligning the valve hole (G) with the threaded hole (H)
in the crankcase half and inserting the screw (13).
Tighten the screw (13) to the specified torque (Sect. C 3, Frame tightening torques).
14
13
13
14
15
14
13
13
15
14
G
H