Changing the PIN CODE
To change the existing PIN CODE and activate a new
one, you must open the Setting MENU.
Select PIN option, by pressing button (1) or (2). Once
function is highlighted, press CONFIRM MENU
button (4).
Note
If upon accessing this function, the "N : " (New)
and four flashing dashes "- - - -" are shown, it means
that the PIN CODE has never been activated and it is
necessary to do it.
When accessing the function, the display will show
"O:" (old) followed by four flashing dashes " - - - - ".
Note
To change the PIN CODE, you must know the
already stored PIN.
To go back to the previous screen without changing
the PIN CODE, press button (2); as soon as the "EXIT"
box starts flashing, press button (4) again.
Entering the "old" code:
1) Press button (4), one digit starts flashing
indicating "0";
2) Each time you press the button (2) the displayed
number increases by one (+ 1) up to "9" and then
starts back from "0";
3) Each time you press the button (1) the displayed
number decreases by one (- 1) up to "1" and then
starts back from "0";
4) To confirm the number, press the button (4);
Repeat the procedures until you confirm all the four
digits of the PIN CODE.
134
To Next Page