If the teach-in procedure is completed correctly, the
instrument panel shows “Completed” followed by
the previous menu a few seconds.
If the calibration procedure is by the user,
the instrument panel shows followed by
the previous menu a few seconds.
If, on the other hand, an error or malfunction occurs
during the calibration procedure, the instrument
panel shows “Failed” followed by the previous menu
a few seconds.
Note
During the calibration procedure, the
procedure will stop if the vehicle speed exceeds 100
km/h (62 mph) or the key is turned
Default
●
Enter the SETTING MENU.
●
Use the navigation to select "Tire
Calibration" option and press ENTER
●
Select the "Default" option and press ENTER
to restore default values.
●
The message "Default Please Wait.." is displayed
and a while "Default Ok" for 2 seconds,
then followed by the previous menu.
Completed
Keep Speed
48 - 52 km/h
and Gear 2
Tire Setting
Sport
50
2
Gear
km/h
Fig 116
153
To Next Page
Loading...
