MENU 2: Trip time
The instrument panel calculates and displays the trip
time as hhh:mm followed by TRIP TIME. The
calculation considers the time since TRIP1 was last
reset. When TRIP1 is reset, this value is reset as well.
The time count active phase occurs when the engine
is running and the vehicle is stopped (the time is
automatically stopped when the vehicle is not moving
and the engine is off and restarts when the counting
active phase starts again).
When the reading exceeds 720:00 (720 hours and 00
minutes), the meter is reset and automatically starts
counting from 0 again.
Note
If you change the unit of measurement for an
item connected to Speed (and distance) or
Consumption, the trip time value will be automatically
reset.
To Next Page
Loading...
Need help?
General
