Why won't the pilot light stay lit on my Duluth Forge FLM24-1-LP Gas Heater?
If the pilot light on your Duluth Forge Gas Heater won't stay lit after releasing the control knob, ensure the control knob is fully pressed in and held for at least 30 seconds after the pilot lights. Also, make sure the equipment shutoff valve is fully open and that the thermocouple connection is snug. The thermocouple may also be damaged and need replacing.
What to do if my Duluth Forge FLM24-1-LP burner does not light after ODS/pilot is lit?
If the burner on your Duluth Forge Gas Heater doesn't light after the ODS/pilot is lit, the burner orifice may be clogged or the inlet gas pressure may be too low. Also, the burner orifice diameter may be too small.
Why does my Duluth Forge Gas Heater smell like gas even when it's off?
If you smell gas when your Duluth Forge Gas Heater is off, it could be due to a gas leak or a defective control valve. You should locate and correct any gas leaks.
What to do if my Duluth Forge Gas Heater shuts off while in use?
If your Duluth Forge Gas Heater shuts off during use, it could be due to a lack of fresh air, low line pressure, or a partially clogged ODS/pilot. Try opening a window or door for ventilation. Also, the ODS/pilot may need cleaning.
What to do if my Duluth Forge Gas Heater smells bad?
If your Duluth Forge Gas Heater produces unwanted odors, it might be burning vapors from paint, hair spray, or glues. Open a window to ventilate the room and avoid using odor-causing products while the heater is running. It could also indicate a gas leak, or low fuel supply (Propane models), so check those as well.
Why is there no spark when I press the ignitor button on my Duluth Forge Gas Heater?
If there's no spark when you press the ignitor button on your Duluth Forge Gas Heater, the battery might be low, the ignitor electrode might not be connected, or the ignitor cable could be pinched, wet, or broken. Replace the battery. Reattach or replace the ignitor cable. Replace the electrode or the piezo ignitor.
What to do if my Duluth Forge Gas Heater has a yellow flame?
A yellow flame during burner combustion in your Duluth Forge Gas Heater could mean there's not enough air, the inlet gas pressure is too low, or the gas regulator is defective. Check the burner for dirt and debris, and clean it if necessary. The heater chassis may need to be replaced.
What to do if my Duluth Forge Gas Heater burner is backfiring?
If your Duluth Forge Gas Heater burner is backfiring during combustion, it could be due to a clogged or damaged burner orifice, a damaged burner, or a damaged gas regulator. Clean the burner orifice. The heater chassis may need to be replaced.
Why is there a clicking noise in my Duluth Forge FLM24-1-LP Gas Heater?
A clicking or ticking noise in your Duluth Forge Gas Heater after the burner is lit or shut off is usually due to metal expanding or contracting. If the noise is excessive, contact a qualified service technician.
Why is my Duluth Forge Gas Heater whistling?
A whistling noise from your Duluth Forge Gas Heater when the burner is lit can be caused by turning the control knob to high when the burner is cold. Try turning the control knob to the low position and letting it warm up for a minute. It could also be due to air in the gas line, blocked air passageways, or a dirty burner orifice.
General| Brand | Duluth Forge |
|---|---|
| Model | FLM24-1-LP |
| Category | Gas Heater |
| Language | English |
To Next Page
