EasyManua.ls Logo

Duluth Forge FLM24-1-LP - User Manual

Duluth Forge FLM24-1-LP
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VENT-FREE YELLOW FLAME GAS LOG HEATER
Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 1-855-607-6557, 8:00 am - 4:30 pm CST,
Monday through Friday or email contact@factorybuysdirect.com
WARNING: If the information in this manual is not
followed exactly, a re or explosion may result causing
property damage, personal injury or loss of life.
— Do not store or use gasoline or other ammable va-
pors and liquids in the vicinity of this or any other
appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re
department.
—
Installation and service must be performed by a quali-
ed installer, service agency or the gas supplier.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
MODELS
FLM24-1-LP
FLM24-1-NG
FLT24-1-LP
FLT24-1-NG
CSA/ANS
Z21.11.2 2019
Unvented
Room Heaters

Table of Contents

Questions and Answers

  • M
    mcguirejohnSep 9, 2025
    Why does my Duluth Forge FLM24-1-LP have delayed ignition?
    • R
      ruizjessicaSep 10, 2025
      Delayed ignition of the burner in your Duluth Forge Gas Heater could be due to low manifold pressure or a clogged burner orifice. Clean the burner.
  • O
    oneilldavidSep 12, 2025
    What causes white powder residue on my Duluth Forge Gas Heater?
    • T
      tblackSep 12, 2025
      White powder residue forming on your Duluth Forge Gas Heater is caused by vapors from furniture polish, wax, or carpet cleaners turning into white powder when heated. Turn off the heater when using these products.
  • S
    Sylvia BondSep 14, 2025
    What to do if my Duluth Forge Gas Heater has a slight smoke or odor during initial operation?
    • A
      Andrew OneillSep 14, 2025
      If your Duluth Forge Gas Heater emits a slight smoke or odor during initial operation, it's likely due to residues from the manufacturing process. This problem should stop after a few hours of operation.
  • R
    Rachael GibbsSep 16, 2025
    What to do if there is a spark but no ignition on my Duluth Forge FLM24-1-LP?
    • D
      Deborah WilliamsSep 16, 2025
      If there's a spark but no ignition on your Duluth Forge Gas Heater, make sure the gas supply is turned on, the control knob is in the PILOT position, and the control knob is fully pressed in while pressing the ignitor button. If it's a new installation, there might be air in the gas lines, so continue holding down the control knob and repeat the igniting operation until the air is removed. The ODS/pilot may also be clogged. Also, check if the propane supply is depleted.

Duluth Forge FLM24-1-LP Specifications

General IconGeneral
BrandDuluth Forge
ModelFLM24-1-LP
CategoryGas Heater
LanguageEnglish

Related product manuals