Duncan Enviro DD35 - Sowing Chart -FINE Seed

21
Pt. No. 67439
Issue 1120
‘Enviro DD35’ Sowing Chart Fine
Box contents
Butterfly Position (affects rear box) Fan Speed/rpm*
FRONT REAR
seed (Normal) seed (Normal) open - 5 3000
seed (Normal) seed (Fine) closed - 1 3000
Fertilizer seed (Normal) closed -2 3000 to 3500
Fertilizer seed (Fine) closed - 1 3000 to 3500
* MAXIMUM
PERMISSABLE
FAN SPEED
4000 RPM
FINE SEED (toggle 'FINE')
27R DD35
PRODUCT
SPECIFIC
GRAVITY (kg/l)
Setting
Position> 2.5 5 7.5 10 12.5 15 17.5 20 22.5 25
RATE ONCE SET DO NOT REDUCE/CLOSE WITH SEED IN BIN**
Lucerne (Alfalfa) 0.8 low 0.9 2.6 3.9 5.5 6.7 7.9 9.5 10.9 12.1 13.1
Turnip 0.7 low 0.9 1.9 2.9 3.8 4.8 5.8 6.7 7.7 8.6 9.6
Kale 0.7 low 0.9 1.9 2.9 3.8 4.8 5.8 6.7 7.7 8.6 9.6
Swedes 0.7 low 0.9 1.9 2.9 3.8 4.8 5.8 6.7 7.7 8.6 9.6
Canola/Rape 0.7 low 0.9 1.9 2.9 3.8 4.8 5.8 6.7 7.7 8.6 9.6
White Clover 0.8 low 1.0 2.2 3.6 5.1 6.5 7.6 9.0 10.1 11.2 11.6
Red Clover 0.8 low 1.0 2.2 3.6 5.1 6.5 7.6 9.0 10.1 11.2 11.6
Grass 0.4 low 1.2 2.2 3.0 3.9 4.7 5.6 6.3 6.8
Millet 0.6 low 0.9 1.9 3.1 4.1 4.9 5.7 6.9 7.8 8.7
Grain Sorghum 0.6 low 0.3 2.4 5.1 6.3 7.2 8.9 10.3 11.6 13.2
Forage Sorghum 0.6 low 0.3 2.4 5.1 6.3 7.2 8.9 10.3 11.6 13.2
Chicory 0.5 low 0.5 1.6 2.4 3.4 4.3 5.3 6.4 7.3 8.0 8.8
Lucerne (Alfalfa) 0.8 high 1.9 5.2 7.8 11.0 13.4 15.8 19.0 21.9 24.3 26.2
Turnip 0.7 high 1.9 3.9 5.7 7.7 9.6 11.6 13.4 15.4 17.3 19.2
Kale 0.7 high 1.9 3.9 5.7 7.7 9.6 11.6 13.4 15.4 17.3 19.2
Swedes 0.7 high 1.9 3.9 5.7 7.7 9.6 11.6 13.4 15.4 17.3 19.2
Canola/Rape 0.7 high 1.9 3.9 5.7 7.7 9.6 11.6 13.4 15.4 17.3 19.2
White Clover 0.8 high 1.9 4.5 7.3 10.1 12.9 15.2 18.0 20.3 22.4 23.2
Red Clover 0.8 high 1.9 4.5 7.3 10.1 12.9 15.2 18.0 20.3 22.4 23.2
Grass 0.4 high 2.4 4.4 6.1 7.8 9.5 11.1 12.7 13.7
Millet 0.6 high 1.9 3.9 6.1 8.1 9.8 11.5 13.8 15.5 17.4
Grain Sorghum 0.6 high 0.5 4.7 10.1 12.7 14.3 17.7 20.6 23.1 26.5
Forage Sorghum 0.6 high 0.5 4.7 10.1 12.7 14.3 17.7 20.6 23.1 26.5
Chicory 0.5 high 1.0 3.1 4.9 6.9 8.5 10.5 12.7 14.5 16.1 17.5
**Setting may only be reduced by a large amount if unit is turning or bin and metering device clear of
product else damage will occur. Do not open the setting above '25' with the toggle set to 'fine' as the
adjuster will break.