To Next PageTo Next Page
Need help?Do you have a question about the Dungs GasMultiBloc MB-D B01 Series and is the answer not in the manual?
General| Series | B01 |
|---|---|
| Protection class | IP54 |
| Type | MB-D B01 |
| Suitable Gases | Natural gas, LPG, and other non-corrosive gases |
| Max. operating pressure | 500 mbar |
| Operating Voltage | 230 V AC |
| Ambient temperature | -20°C to +60°C |
| Approvals | CE, DVGW |
| Material | Aluminum |
| Media temperature range | -20°C to +60°C |
| Application | For shutting off and controlling gas and air flows. For use in gas burners, gas engines, boilers and other gas consuming appliances. |
Introduces the MB-D (LE) B01 model and its basic features.
Overview of various EU compliance declarations for the product.
States the manufacturer, location, and product type.
Lists relevant EU regulations for gas appliances and pressure equipment.
Identifies the certificate holder and product details.
Lists the standards the product was tested against and its validity period.
Identifies the certificate holder and product details.
Lists the standards used for testing and the certificate's validity.
Details product model, operating mode, and nominal diameters.
Covers installation, electrical, pressure, temperature, protection, and gas type.
Provides dimensions, mounting details, and torque specifications.
Details product types, opening times, and weights.
Instructions on tool usage and avoiding improper handling.
Identifies valve electrical connections and related components.
Details pressure switches, input/output flanges, and gas flow direction.
Identifies operation indicators, filter housings, and sealing caps.
Guides through loosening screws and removing the MultiBloc.
Emphasizes performing leakage and functional tests after installation.
Details steps for dismounting the hood and setting the pressure switch.
Stresses following burner manufacturer instructions and checking switch operation.
Guides on adjusting the pressure regulator to the desired output pressure.
Details the steps for applying lead seals after adjustment.
Explains how to adjust the main flow setting on MB-D models.
Notes that main flow setting is not possible on MB-DLE models.
Guides on adjusting rapid stroke using the adjustment cap as a tool.
Details steps for replacing the hydraulic unit or adjustment plate.
Emphasizes performing leakage and functional tests after replacement.
Advises checking the filter annually and when pressure drop exceeds 10 mbar.
Outlines the steps for changing the filter without removing the unit.
Provides curves for selecting MB 415/420 based on flow rate and pressure.
Highlights the recommended operating range for the equipment.
Presents flow curves for mechanically open or filtered MB units.
Lists densities and conversion factors for various gases.
Covers essential safety precautions for working on the GasMultiBloc.
Provides guidance on setting, sealing, and using new gaskets.
Highlights severe risks like working with gas pressure or power applied.
Details the designed lifetime and operating cycles for safety-relevant components.
Advises on replacing components after their useful life or based on specific criteria.
