General
Boiler installation shall be completed by qualified agency.
See glossary for additional information.
Fire, explosion, asphyxiation and electrical shock
hazard. Improper installation could result in death
or serious injury. Read this manual and understand
all requirements before beginning installation.
Keep this manual near boiler
Retain for future reference
Installation shall conform to requirements of
authority having jurisdiction or in absence of such
requirements:
• United States
° National Fuel Gas Code, ANSI Z223.1/NFPA 54.
° National Electrical Code, NFPA 70.
° Canada
° Natural Gas and Propane Installation Code, CAN/CSA
B149.1.
° Canadian Electrical Code, Part 1, Safety Standard for
Electrical Installations, CSA C22.1
Become familiar with symbols identifying
potential hazards.
This is the safety alert symbol. Symbol alerts you to
potential personal injury hazards, Obey all safety messages
following this symbol to avoid possible injury or death,
Indicates a hazardous situation which, if not avoided,
WILL result in death or serious injury
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicatesa hazardous situationwhich, ifnot avoided,
could result in minor or moderate injury.
Where required by authority having jurisdiction,
installation shall conform to Standard for Controls
and Safety Devices for Automatically Fired Boilers,
ANSI/AS/VlE CSD-1.
Additional manual reset low water cutoff and/or manual
reset high limit may be required.
Requirements for Commonwealth of
Massachusetts:
Boiler installation must conform to Commonwealth of
Massachusetts code 248 CMR which includes but is not
limited to:
° Installation by licensed plumber or gas fitter.
Installers - Follow local regulations with respect to
installation of CO (Carbon Monoxide) Detectors. Follow
maintenance recommendations"Maintenance And Cleaning"
on page 47.
Used to address practices not related to personal
injury.
To Next Page
Loading...
