What to do if there is a gas valve command fault in Dunkirk Boiler?
If you're experiencing a gas valve command fault with your Dunkirk Boiler, the first step is to carefully check all the cables connected to the gas valve command system. If the issue persists after verifying the cable connections, it may be necessary to replace the PCB (Printed Circuit Board).
What to do if the Dunkirk DCBF-100 Boiler shows outdoor sensor fault?
If you're encountering an outdoor sensor fault with your Dunkirk Boiler, you should inspect the sensor itself and its connecting cable to ensure they are in good condition and properly connected.
What to do if there is an obstruction in flue pipe, recirculation, out of calibration, or poor gas quality in Dunkirk DCBF-100?
If you suspect an obstruction in the flue pipe, recirculation issues, calibration problems, or poor gas quality in your Dunkirk Boiler, begin by inspecting the flue pipe for any obstructions. Then, verify the gas pressure and check the gas orifice. Also, check for recirculation issues, recalibrate the system if necessary, and assess the gas quality.
What to do if I see a gas valve command fault on my Dunkirk DCBF-100 Boiler?
If your Dunkirk Boiler displays a 'Gas valve command fault', begin by verifying all cable connections. If the problem persists, consider replacing the PCB. If the issue still isn't resolved, it's recommended to call an authorized service center for assistance.
How to fix gas valve connection fault in Dunkirk DCBF-100?
If your Dunkirk Boiler is showing a 'Gas valve connection fault', you should check the cable connecting the PCB to the gas valve, as well as the gas valve plug itself.
What to do if there is a Domestic Hot Water NTC sensor fault in Dunkirk Boiler?
If your Dunkirk Boiler is showing a 'Domestic Hot Water NTC sensor fault', you should check the sensor and its cable.
What to do if there is a Return NTC sensor fault in Dunkirk DCBF-100 Boiler?
If your Dunkirk Boiler is showing a 'Return NTC sensor fault', you should check the sensor and its cable.
What to do if there is a Flue NTC heat exchanger sensor fault in Dunkirk Boiler?
If your Dunkirk Boiler is showing a 'Flue NTC heat exchanger sensor fault', you should check the sensor and its cable.
What to do if there is a Central Heating NTC sensor fault in Dunkirk DCBF-100 Boiler?
If your Dunkirk Boiler is showing a 'Central Heating NTC sensor fault', you should check the sensor and its cable.
What to do if there is an outdoor sensor fault in Dunkirk DCBF-100?
If your Dunkirk Boiler is showing an 'Outdoor sensor fault', you should check the sensor and its cable.
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Input BTU | 100, 000 BTU/hr |
| Heating Capacity | 85, 000 BTU/hr |
| Weight | 180 lbs |
| Vent Type | Direct Vent |
To Next Page
