Duplo DB-200 User Manual

~56~
1. Open the clamps to the maximum position then turn off the power of the machine.
2. Take apart the clamps from the clamp station.
3. Clean the residual glue that might be on the clamps.
4. Install the clamps to the clamp station.
5. Turn on the power of the machine.
6. Clamp some inner pages to see if the clamps have been installed properly. If clamp adjustment need, please refer
to A1 section of Appendix for details.
(2) Notching Station
This is a monthly maintenance. However, we recommend that you should use vacuum to clean the paper dust on the
notching station when the machine has made 2,000 books.
Warning: You must power off the machine in order to perform the notching blade
maintenance.
1. Power off the machine.
2. Remove the notching covers.
3. Use the vacuum to clean up the paper dust.
4. Clean up the residual glue around the notching wheel, rollers and blade.
5. Clean the notching covers, notching blade, and rollers.
6. Check to see if the notching blade has been worn out or broken. If so, replace a new one.
7. Install the notching covers.
5.2 Lubrication
5.1.1 All operating components such as chains, chain sprockets, gears, racks shall be routinely added with
lubricating oil or grease.
5.2.2 All rotating joints at spindle ends attached with oil cups shall be routinely filled with lube oil.
5.3 Trouble Shooting
In case, when the control panel display error message, please refer to following step to correct.

Duplo DB-200 Specifications

General

Brand	Duplo
Model	DB-200
Category	Binding Machine
Language	English