Duplo DP-S850 - Master Feed Section

110
c Platemaking/Master Feed and Ejection Section
chap.3
(2) Removal of End Mark Sensor PCB Unit
1. Open the scanner, and take out the master roll.
2. Open the master cover.
3. Remove the 2 screws, and remove the cover.
4. Remove the 2 screws.
5. Disconnect the connector indicated, and the end
mark sensor PCB unit.
CLOSE
CLOSE
R8S03035
R8S03036
Screw
Cover
Screws
Connector
Cover
End mark sensor PCB unit
Screw