244
c HELP Mode Function and Operation Procedures
chap.7
Paper Feed Adjustment (5 pages in total)
2
To enter H-039, be sure to set G of HELP-061 (5 at Page 2) to 1.
Page 1: Paper feed speed
Page 2: Paper feed angle
Page 3: Paper feed lead edge sensor angle
Page 4: Paper feed limit angle
Page 5: Paper feed loop level
¡ Operation procedure
3.
Set value display (Page 5).
Paper feed loop levels are displayed.
HELP-031 to HELP-038 unused
4.
Unchangeable
1.
Enter
“
039
”
by the
NUMERIC
keys and then press the
(PRINT)
key. Memory check starts.
Call the HELP mode
“
H-039
”
.
2.
Touch the
(
arrow
)
on the screen lower right four times to switch
to Page 5.
Change the screen.
¡
Do not change the values at Pages 1
- 4.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
Press the (STOP) key.
The HELP mode selection display will reappear.
Return to the HELP mode.
To Next Page
Loading...