Dupray ONE - Connecting and Operating the Steam Hose; Adjusting Steam Pressure; Refilling and Turning Off; Storing Your Steam Cleaner

TRAINING VIDEOS
AT DUPRAY.COM
COOL DOWN
FOR 10 MINUTES
CONNECTING THE STEAM HOSE
Connect the steam hose by inserting the steam hose connector in the steam hose connection outlet and
press firmly. Make sure it cannot be pushed in any further and that the locking pin on the flap is in place.
ADJUSTING THE STEAM PRESSURE
Adjust the desired steam pressure using the steam pressure regulator wheel located on the hose handle,
from minimum (-) to maximum (+). Connect the accessory that you want to use to the steam hose.
To release steam, simply press the steam release trigger on the hose handle.
REFILLING WITH WATER
When steam runs out or if the low water indicator (8) comes on during usage and you would like to continue using the steam cleaner, you will
need to follow these steps:
TURNING THE MACHINE OFF
When you are done using your steam cleaner, turn the main dial to the OFF position and
unplug the unit.
STORING YOUR STEAM CLEANER
It is safe to leave water in the boiler when the steam cleaner is not in use.
If it is for an extended period of time (months), then it is best to flush out the remaining water.
To do so, follow the water removal instructions as outlined in the maintenance of the
boiler section on page 17.
CAUTION:
This machine shall be stored indoors only.
IMPORTANT: Do not overfill. Leave space for steam !
IMPORTANT: Make sure the locking pin on the flap is inserted in the hose connection.
WARNING: If all steam pressure has not been released, steam may escape from the cap when opening, use caution.
When there is no more steam,
wait 10 minutes for the boiler
to cool down.
Turn the main dial to the OFF
position (this shuts o the
power to the heating element).
Hold the steam release trigger on
the handle until all the steam has
evacuated the steam cleaner (the
pressure gauge must be at zero).
Open the boiler cap slowly and refill
the steam cleaner with 700ml (23 oz)
to 1L (34oz) of water. Refasten the boiler
cap, turn the main dial to the position
and wait for the SteamReady™ indicator
to turn on.
10
en