DURABLE 5085 - Assembly Instructions; Table Clamp Mount Assembly (#5085); Cable Hole Mount Assembly (#5086)

EN

English
Note:
Please contact our service team if one of the parts are
missing or damaged.
Assembly
– Take all parts out of the packaging.
Table clamp table mount (product variant #5085)
▶see figure4
– Slide the table mount (6) until it meets the table edge.
– Tighten the clamping screw(7) with the enclosed allen key.
Cable hole table mount
(product variant #5086)
▶see figure5
WARNING!
Risk of property damage!
Take care not to clamp in or squeeze any cables.
– Feed the cable through the hole in the table plate and the open-
ing provided for the purpose in the table mount (8).
– Feed the clamping screw (10) through the pressure plate (9) into
the table mount (8) and secure it with the enclosed allen key.