DURABLE 5085 - Operation; Rotating Range; Tilt Adjustment; Height Adjustment

EN

English
▶see figure10
– Insert the VESA plate(1) into the bracket(15). Make sure that
the plate locks in fully.
▶see figure11
– Rotate the monitor to the desired position.
▶see figure12
– Insert the cables into the monitors.
– Insert the cables into the enclosed square cable clamps(21) on
the monitor as shown.
– Secure the cable clamps (21) and (22) on the monitor arm as
shown.
– Route the cable on the monitor arm along to the centre and se-
cure this with another square cable clamp (21) together with the
cables of the second monitor.
Operation
– Place the monitor in the desired position.
Rotating range
▶see figure13
Tilt adjustment
▶see figure13
– If the monitor tilts independently or is very difficult to tilt, adjust
the braking effect using the screw (14) in the joint.
Height adjustment
▶see figure14
– Loosen the adjusting screw (12).
– Push the arm bracket (4) into the desired position on the table
column (5).
– Secure the monitor arm again using the adjusting screw (12).