Duraflame DFS-550-20 - User Manual

Your replace consists of a fan-forced
wire element type heater. Press the
HEAT button will cycle through 750W,
1500W and OFF settings. If using the
remote control, please note that the
heater will beep once when set on
750W and beep twice when set on
1500W.
- POWER
- HEATER
Made in China
Printed in China
© 2012, Twin-Star International,Inc.
VOLTAGE 120 VAC, 60 Hz
AMPS 12.5 Amps
WATTS (Max.) 1500 Watts
OPERATING INSTRUCTIONSASSEMBLY INSTRUCTIONS
PRODUCT SPECIFICATIONS
The Power button supplies power to all
of the functions of the stove.
NOTE: Holding the POWER button on
the control panel for 10 seconds will
disable the heater function. Re-activate
the heater function by holding this
button for 10 seconds again. The lights
will ash several times when this
function is activated.
Use + - to increase or decrease the
ame brightness levels.
For Customer Service:
www.twinstarhome.com
888-674-7517
8:30 a.m.-5:30 p.m., EST, Monday-Friday
1 2
3
Distributed by
Twin-Star International, Inc. Under license.
duraflame™ and the duraflame flame
logo are trademarks of Duraflame, Inc.
Twin-Star International, Inc.
Delray Beach, FL 33445
Made in China • Printed in China
MOUNTING THE LEGS
1. Attach the legs to the bracket as shown in Fig. 1.
2. Fasten the legs to the base using the included screws (1 per leg).
MOUNTING THE DOOR PULL
3. Insert the handle into the front hole of the door. Insert washer and
screw as shown in Fig. 3., and tighten with a phillips head screwdriver.
- ( + - ) BRIGHTNESS
MODELS: DFS-550-20, DFS-550-24, DFS-550-25, DFS-550-26,
DFS-550-27, DFS-550-28, DFS-550-29, DFS-550-30
Leg
Bracket

Duraflame DFS-550-20 Specifications