ASSEMBLY (PNF)
1.
Out of the box your Tundra comes with reinforced foam hinges. However, before you start the
assembly, each hinge line must be flexed back and forth 5 to 6 times to reduce the tension and load
on the servo. Do this to all the control surfaces before continuing. The aileron pushrods are factory
installed, so you will need to use some pliers, or better still, ball-link pliers to pop the ball-link
connector off the control horn before you do this.
2A.To mount the undercarriage to the fuselage, start by inserting and securing the two rear braces with
the supplied M2.5x8mm hex screws (A). Now insert the main gear wire into the fuselage slot and
slide the plastic brace keepers over the rear braces (B) to bring these two parts together. Insert the
spring support wire between the main gear wire (C) . Use
the supplied M2.5x8mm hex bolts to
secure the main gear and spring support wire in place with the plastic undercarriage straps (D).
Notes:
Ensure the main gear rakes forward at stage B.
Note left (L) and right (R) marked plastic straps and install accordingly during stage D.
.
B.
C.
D.
A.
M2.5x8mm
M2.5x8mm
3
To Next Page
Loading...
