How to fix excessive flames on DuraHeat TT-15CSA Heater burner?
If you're seeing excessive flames coming out of the burner of your DuraHeat Heater and it's not glowing red, it could be due to: 1. Debris or spider webs in the mixing tube or burner. Clean the burner tube with a bottle brush, rinse in water, and drain thoroughly before reinstalling. 2. A clogged orifice. Remove it and clean it using compressed air.
Why won't my DuraHeat TT-15CSA light?
There are several reasons why your DuraHeat Heater might not be lighting: 1. The valve on the propane cylinder might not be open. Open it by turning counterclockwise. 2. The propane cylinder could be empty. Refill the cylinder. 3. The regulator might not be in the "High" position. Turn the regulator to "High". 4. The excess flow device may have been triggered. Close the cylinder valve, wait 5 minutes, and reopen it slowly. 5. The regulator could be defective. Replace the regulator assembly.
What to do if DuraHeat TT-15CSA Heater burner won't stay lit?
If the burner on your DuraHeat Heater won't stay lit after releasing the gas valve plunger, here's what could be happening: 1. The tilt switch may be open. Ensure the unit is aligned vertically. 2. There might be an issue with the thermocouple wiring. Check that the wiring connections are properly engaged. 3. The thermocouple could be defective. Replace the thermocouple. 4. The tilt switch might be defective. Replace the tilt switch. 5. The gas valve could be defective. Replace the gas valve assembly.
What causes flames flashback in DuraHeat TT-15CSA Heater mixing tube?
Flames flashback or burning inside the mixing tube of your DuraHeat Heater can be caused by: 1. Debris or spider webs in the mixing tube. Clean the burner tube with a bottle brush, rinse in water, and drain thoroughly before reinstalling. 2. A clogged orifice. Remove it and clean it using compressed air.
How to fix a DuraHeat Heater piezo that won't spark?
If the piezo on your DuraHeat Heater isn't sparking (for models with a piezo), consider the following: 1. The piezo may be defective. Replace the piezo. 2. The ignitor might be misaligned with the thermocouple shield. Realign the ignitor with the thermocouple shield. 3. The wire could be frayed or damaged. Replace the wire.
Key safety guidelines including clearance, placement, and use restrictions.
Steps and safety precautions for refilling propane cylinders.
Step-by-step guide for igniting the heater using a match.
Instructions for lighting the heater using the built-in piezo ignitor.
General| Heating Capacity | 15, 000 BTU |
|---|---|
| Dimensions | 17.1 in x 7.9 in x 13.1 in |
| Weight | 11 lbs |
| Voltage | 120V |
| Heating Method | Forced Air |
| Adjustable Thermostat | No |
| Overheat Protection | Yes |
| Fan | Yes |
| Fuel Type | Kerosene |
| Power | 120V AC |
| Safety Features | Overheat Protection, Tip-Over Switch |
To Next Page
