Name: DuraLabel 9000
Brand: DuraLabel
Rating: 5 (1 reviews)

Other manuals for DuraLabel 9000

User Guide56 pages

Manual53 pages

Questions and Answers:

Y
ycollinsJul 30, 2025
Why is my DuraLabel 9000 not printing?
- H
  hendersoncarolynJul 30, 2025
  If your DuraLabel Printer is not printing, there could be several reasons. First, ensure the cable is securely connected to the serial, USB interface, or parallel port. If you're using a serial cable, verify it's pin-to-pin connected, or replace it. Check the baud rate setting (default is 9600,n,8,1). If using Ethernet, check if the green LED is lit and the amber LED is blinking on the RJ-45 connector. Also, confirm the printer gets the correct IP address in DHCP or static IP mode. Other potential issues include incompatible ribbon and media (ensure the ribbon-inked side faces the correct way), incorrect print density settings, or a loose print head harness connector (turn off the printer and reconnect it).
M
Mary WilliamsAug 3, 2025
What to do if my DuraLabel 9000 has a paper jam?
- J
  John HancockAug 3, 2025
  If your DuraLabel Printer has a paper jam, it could be due to several reasons. Make sure the media is loaded correctly and adjust the sensor to the appropriate location. Calibrate the gap/black-mark sensor. Ensure the label supply size is set correctly. Also, check for any labels stuck inside the printer mechanism.
D
Denise DavidAug 7, 2025
Why does my DuraLabel Printer say 'No Paper'?
- K
  Kayla ClarkAug 7, 2025
  If your DuraLabel Printer indicates 'No Paper', it may be due to the label supply being empty. Supply a new label supply roll. Alternatively, the label might be installed incorrectly; refer to the user’s guide for reinstallation steps. If you are using gap/black-mark material, the gap/black-mark sensor may need calibration.
D
Dorothy RhodesAug 12, 2025
What to do if my DuraLabel Printer says 'No Ribbon'?
- R
  Rachel MunozAug 12, 2025
  If your DuraLabel Printer displays 'No Ribbon', it could be due to a lack of ribbon. Supply a new ribbon roll. It could also be that the ribbon is installed incorrectly. Please refer to the steps in the user’s guide to reinstall the ribbon.
M
millsmarkAug 16, 2025
What does 'UP: Fwd. DOWN: Rev. MENU: Exit' mean on my DuraLabel 9000 Printer?
- B
  Brian GlennAug 16, 2025
  This message on your DuraLabel Printer indicates a potential cutter issue. If a cutter module is installed, press the UP or DOWN key to adjust the blade position. If there is no cutter installed, remove the label. In case the cutter PCB is damaged, it needs to be replaced.