TROUBLESHOOTING
12
1. Motor fails to run or lacks power:
• Check motor for obstructions. The motor may have gone into current limit. To reset:
return to off position, remove obstruction and resume operation.
• Check battery connections for proper polarity.
• Make sure terminals are clean and corrosion free. Use fine sandpaper or emery
cloth to clean terminals.
• Check battery water level. Add water if needed.
2. Motor looses power after a short running time:
• Check battery charge, if low, restore to full charge.
3. Motor is hard to steer:
• Loosen the steering tension knob on the back of bracket.
• Lubricate the composite shaft.
4. Your experience prop vibration during normal operation:
• Remove and rotate the prop 180º. See removal instructions in prop section.
NOTE: If you do not understand the warnings and instructions in this Owner's
manual, do not use this product. Call DURAMAXX
TM
customer service for
assistance.
To Next Page
Loading...
General