BATTERY
9
BATTERY CONNECTION
12 V Systems
1. Connect the positive (+) red lead to the positive (+) battery terminal.
2. Connect the negative (-) blace lead to the negative (-) battery terminal.
NOTE:
If installing a leadwire plug, observe proper polarity and follow instructions in
your boat owner’s manual.
IMPORTANT:
This is supplied as a quick reference guide however battery types,
brands and sizes may vary in performance and abilities. Always read your battery
manufacturers manual for specific battery requirements or contact the manufacturer for
best practices and/or advice.
WARNING:
• Before connecting battery, make sure the tiller twist handle is in the off
position.
• Use only 6 gauge wire to extend power lead.
• Improper wiring of 12 V system could cause battery explosion!
• Keep leadwire wing nut connection tight and solid to the battery terminals.
• Locate battery in a ventilated compartment.
To Next Page
Loading...
General