3
Assembly Instruction
1. Unfold the Hull
Remove the hull from its box and take it out of the boat bag. Clear a flat
space, making sure it is clean and free of sharp objects, and unfold your boat
so it is laid out flat.
2. Inflate slightly
Inflate tube chambers to approximately 30%. Inflate side tubes first, then the
bow tube(s). Install either floorboards or air floor.
NOTICE: Do not use an air compressor to inflate your boat. Damage to
your boat caused by over inflation is not covered by your Limited Warranty.
3. Floorboard Assembly
DX86, DX96, DX104, DX126
a. Place floorboard No. 1 at the bow of boat, then place floorboard No.4 at
transom, then place floorboards No. 2 and No. 3 as shown in diagram.
• Make sure that keel valve is located at the center of the hole in
floorboard No.1.
b. Press down on floorboard No. 2 and No. 3 at the same time so that the
floorboards lay flat.
DX138
a. Attach floorboard No. 1 and No.2 and install at the bow of boat, then
place floorboard No.5 at transom, then place floorboards No. 3 and No.
4 as shown in diagram.
• Make sure that keel valve is located at the center of the hole in
floorboard No.1.
b. Press down on floorboard No. 3 and No. 4 at the same time so that the
floorboards lay flat
Do not assemble the floorboards with bare feet, and keep your fingers and toes
out of the way to avoid getting pinched.
To Next Page
Loading...