Duro 6200 SXT - Water Conditioner Flow and Setup; Flow Diagrams: Service, Backwash, Rapid Rinse; Initial Backwash Procedure; Rapid Rinse and Return to Service

16
6. Make sure the bypass valve is in the
service position.
7. Plug the 24-volt transformer into a
120 VAC 60 Hz outlet.
8. This valve has two positions: 1)
Backwash and 2) Rapid Rinse. When
the valve is in the Service position
must be pressed and held for
5 seconds before it activates. Press
and hold the
pic for 5 seconds
to advance the valve into the “1”
Backwash position. Press once more
to advance to the “2” position.
outlet
intlet
Circuit Board Screen
Brine Cam
Position Label
15
Cycle Step Abbreviation
BW Backwash
RR Rapid Rinse
SV Service
The valve position during regenera-
tion and servicing can be checked
in the circuit board screen as well
the position label on the cam.

6

7

8