Duronic VC7020 - Assembling the Vacuum Cleaner; How to Use

7
Assembling the Vacuum Cleaner
How to Use
Insert the hose connector in
front of the vacuum cleaner
into the inlet hole, then turn it
to the right (clockwise) to lock
it in place.
If you ever need to
disassemble the vacuum, you
can turn the hose connection
back to the left and pull it out.
Pull the power cable out of
the vacuum, ensuring that you
stop when you see the yellow
mark.
Make sure that the red mark is
not visible; if it is, this means
you have pulled the cable out
too far.
Attach the telescopic tube to
the exi hose.
If you ever need to
disassemble the vacuum,
you can pull these apart to
separate them.
Attach the telescopic tube to
the exi hose.
If you ever need to
disassemble the vacuum,
you can pull these apart to
separate them.
Insert the telescopic tube into
the opening on the oor brush
(or turbo brush if preferred).
Rotate the brush to fasten it
on securely.
When you nish vacuuming,
turn off the power and unplug
from the mains socket. Push
down the rewind handle/
button to wind the cable back
into the machine.
Use your other hand to guide
the cable to ensure it doesn’t
whip back and cause injury.
1
4
2
5
3
6