Duruxx DRX2 - Troubleshooting: Dynamo, Clutch, and Noise

78
10 Dynamo
default/ not
working
Rotor/stator loop open
circuit/short
circuit/connect iron
Replace or repair
rectifying tube burnt/open
circuit/short circuit
Replace or repair
Necking insulate is
defective
，
lead line cut off
Replace or repair
11 Dynamo under
power
Ring header is defective
Replace
Electric brush
disconnection, oil stain is
on slip ring
Purge oil stain
12 Dynamo has
abnormal sound
Loose/noise bearing
Replace or fill lubrication
grease for adjusting
rotor and stator collision
Adjust
Ring header is short circuit
Replace
Stator winding is short
circuit
Replace
13 Clutch slip
Oil stain is on friction
piece
Remove or purge
Friction piece wear off
badly
Replace
14 The clutch is
shaking with noise
Worn/not free separation
bearing
Replace/adjust lubrication
grease for purging
Worn/not free first bearing Replace
Loose clutch spline hub
Repair
Loose platen/membrane
spring
Repair or replace
Flaw is on clutch platen
Replace
Worn clutch absorber spring
Replace