Dux proflo 25S124P User Manual

Owner’s Manual – Proflo 25/50 Litre Water Heater
6
028299 Rev. B
Electrical Connection
General:
This water heater is designed for single
phase 240V a.c. supply only. The electrical
connection must comply with Local Supply
Authority Regulations and AS/NZS 3000.
Pre-Wired Models:
Water heaters with the letter “P” at the end
of their model number are factory tted with
a power supply cord. These water heaters
may be plugged into a standard general
purpose power outlet.
If the power supply cord is damaged, it must
be replaced by the manufacturer, a service
agent or a similarly qualied person in order
to avoid a hazard.
“Hard Wired” Models:
Water heaters without the letter “P” at the
end of their model number are not factory
tted with a power cord.
Connection of the electrical wiring must only
be carried out by a licensed tradesperson.
Before removing the electrical cover, ensure
the electrical power supply is safely isolated.
Connections are made at the terminal
block under the water heater electrical
cover, and a means for disconnection
must be incorporated in the xed wiring in
accordance with the Wiring Rules.
The electrical cover may be removed by
undoing the two screws at the bottom of the
cover and sliding the cover downwards to
disengage the top edge.
Cable entry to the connection area is through
the hole in the case beneath the electrical
cover, designed to accept a 20mm conduit.
Ensure the conduit entry is well sealed to
achieve the correct weatherproong.
When the supply wiring has been connected,
ensure the wires are kept lower than the
terminal block.
Before replacing the electrical cover, press
the reset button on the thermostat to ensure
the over-temperature energy cut-out is set.
Ensure the water heater is lled with
water before turning on the electricity
supply.

Dux proflo 25S124P Specifications

General

Brand	Dux
Model	proflo 25S124P
Category	Water Heater
Language	English