11
Error Guide:
If an error code appears in the LED DISPLAY, follow the Instructions in the Error Code table (below)
to correct the problem.
Replacement table and comments for error codes on page 11.
*
Unit will shut off automatically after 1-minute. This is a safety feature to prevent overheating and
damage to cooktop.
Note: If any of the above remedies fail to correct the problem, please contact CustomerCare@
thesecura.com.
Error
Code
Problem Solution
E0*
No cookware detected. Place compatible cookware on surface.
incompatible cookware detected. Place compatible cookware on surface.
Cookware not centered on
ALIGNMENT GUIDE.
Center cookware on ALIGNMENT GUIDE.
E1
Excessive high temperature.
1. Remove cookware and unplug unit.
2. Ensure 4” clearance on all sides of unit for proper
ventilation.
3. Allow 10 minutes for unit to cool down and then
connect unit to a 120V outlet.
4. Place compatible cookware on unit.
5. Touch ON/OFF button and confi rm fan is operating.
Cooking malfunction.
Inadequate ventilation.
E2*
Cooking surface temperature
exceeds 460°F (238°C).
If in POWER MODE, switch to TEMPERATURE
MODE.
If boiling liquids, follow steps for E1 above.
E3*
Voltage input is either too high
or low.
1. Unplug unit from outlet.
2. Verify the outlet is 110/120V AC.
3. If not, switch to proper outlet or consult an
electrician.
140°
When in POWER mode, cooktop
switches automatically to the
lowest TEMPERATURE mode
(140°).
This is not an error code or malfunction. This built-
in safety feature protects your food from being
overcooked and your cooktop from overheating. Please
refer to the TROUBLESHOOTING GUIDE on the
previous page for more information.
Copyright 2010 - 2018 Secura, Inc. All rights reserved. www.duxtop.com / www.thesecura.com
Induction Cooktop
To Next Page
Loading...
