Phone 0800 387 387 | www.dvs.co.nz
Holding down the button for 5 seconds will enter
the shortcut for setting the High Temperature Cut out.
Both LEDs (house and supply) will ash.
The system will shut o when the supply air is above this
temperature.
The display will show the current High Temp cut out
temperature, or “0F” if the feature is o. Pressing
or will change the cut out temperature, and
ensure the High Temperature cut out feature is activated.
The feature can be turned o by pressing or
until “0F” is displayed.
After 15 seconds without pressing a button, the menu
will exit and return to Fan Operation ON / OFF display.
Turning high temperature
cut out on and o
(Factory set to 27
o
)
Pressing either or while displaying House
temperature or Supply temperature will change to
displaying the FAN ON or FAN OFF indication
Main Display
Please note: ‘OF’ on the controller means ‘OFF’
To Next Page
Loading...
